Pirate4x4.Com : 4x4 and Off-Road Forum - View Single Post - FJ80-based 4-seater truggy build at Pacific Fabrication
View Single Post
Old 09-12-2011, 10:28 PM   #10 (permalink)
JESSE_at_TLT
Registered User
 
Join Date: May 2004
Member # 30721
Location: on the road
Posts: 3,713
Here is a picture of a tube being notched on the chassis. The JMR bother is great for that. In this case, we just found it easier to float this particular tube using temporary support tubes that we welded into place, then notching it afterwards. Setting the height, and keeping it level, and keeping it square to the rest of the chassis was difficult enough. Notching afterwards only meant that we didn't have to worry about the rotation and keeping the tube perfectly centered.



__________________
gatosbros.com cruxstudio.com trailslesstraveled.com
JESSE_at_TLT is offline   Reply With Quote