cage/hardtop measurements

[rustyb]

I am about to make a cage for a guy in Tx who has a hardtop on his cruiser. I got rid of my hardtop a couple of years ago and I dont know of anyone around here who has one. I need someone to give me some measurements to go by. I will be using my rig to build the cage on then have it delivered to Tx.
I need the max height and width from floor to roof just behind the windshield. I need the max width behind the seats and width and height in the rear. Any help is greatly appreciated.

[wngrog]

Hello?

[Stupid frnch jackasS]

front : 1270mm w * 1270mm h
middle, rear (before rounded section) : 1460 w * 930 h
(zezo clearance)

Denis

[FIXXXXAH]

AHAHAHA, THE ONLY REPLY IS FROM THE DUDE WHO USES METRIC! :p ALTHOUGH I DO FAR PREFER METRIC OVER STANDARD...

I WOULD MEASURE FOR YOU MAN, BUT MY TOP IS IN A FEILD HALF A MILE AWAY, AND WOULNT BE BACK ON TILL I GET HER FINISHED...


MATT

[Stupid frnch jackasS]

Imperial sucks :flipoff2: :flipoff2:

1" = 25.4mm BTW :flipoff2: :flipoff2:

Oh, and :flipoff2: :flipoff2: :flipoff2:

[rustyb]

merci beaucoup Denis. I think that means'' thanks a lot'' to the rest of you dumb asses. :flipoff2:

[Stupid frnch jackasS]

You're welcome rusty :D Don't forget to take a few cms off my measurements so that the hard-top fits without using a BFH ;)

:beer:

Denis