Hey, i'm looking to replace a 1" qa1 rod end i have (1" shank and 1" bore).

I found the rod end section of your site a little difficult to navigate and couldn't find what i was looking for

Do you offer a 1" hiem of some sort?

YES, we stock the JM series and JMX series by FK Bearing in that size.

JMX16-1T (JMX-16-1T10 in the dropdown for some reason) would be the P/N for the JMX series, on this page. The JMX's are heat treated chromoly steel:
http://www.polyperformance.com/shop/JMX-High-Strength-Rod-End-p-348.html

JM16-1T would be the P/N for the JM series, on this page. These are good if you are trying to save a little coin and the strength doesn't need to be that of the JMX series.
http://www.polyperformance.com/shop/JM-Regular-Strength-Rod-End-p-11.html

awesome, thanks

I'm running this joint on the axle end upper link of my front 3-link. Do you think the jm16-1t would be sufficient for this on a normal trail rig that gets driven to the trails?