Way
01-26-2003, 02:08 PM
I have some 1/4" corner guards that I was planning on using with my bumper. I have since cut out what I was planning on proctecting when performing my fender cutting.
They are 27" in length on the top side. 5.75" on the big side. About 3.75 on the small side. Has an underside lip that goes down at a 45 degree angle. Hard to explain, so I drew a picture as to where these go.
Any of you home fabricators of rear range rover bumpers interested? PM if so. Want to get these out of my garage, and after all of the work, don't want to cut them up. They are generic enough that they may be made to fit other rovers with little work???
Way
*Old Scout let me know if I need to delete this.*
They are 27" in length on the top side. 5.75" on the big side. About 3.75 on the small side. Has an underside lip that goes down at a 45 degree angle. Hard to explain, so I drew a picture as to where these go.
Any of you home fabricators of rear range rover bumpers interested? PM if so. Want to get these out of my garage, and after all of the work, don't want to cut them up. They are generic enough that they may be made to fit other rovers with little work???
Way
*Old Scout let me know if I need to delete this.*