I see that petroworks is selling a z-bar eliminator.
I saw one on ebay from a guy in ElCajon making them.
Anyone here have one of either animal on their rig?

I have the Breeze crossover steering on my rig. The Breeze steering arm is machined from billet steel while the Higher Heights piece that Petroworks sells is cast. I saw a Higher Heights arm break at the 2000 ZukiMelt in Attica IN. I haven't had any problems with my Breeze set-up.

Me and Tusker found part of a Petroworks high steer arm on the back side of little sluice, it was broken clean in half!!! :eek: Sounds like they might snap occasionally, which is too often for me. The Breeze one looks like a sweet design.

i originally got the calmini steering set up a few years ago despite the seeming bad mouthing it gets:flipoff2: it has worked well for me over the years. that beeing said,if the Breeze cross over had been available back then (or if i had known about it if it existed) i definately would have got it.:(
the calmini stuff has needed tightening of the fasteners occasionally (at the frame mounting point) worked fine with bone stock or 7" of spoa for me.:p