its so scary in here for a ford guy, but i need a blow up that hopefully lists part numbers but is not nessecery, but a blow up of the scout Dana 20 case whould work for me, or point me to somewhere that has it

Light Line of Louisiana has a schematic at their web site. Don't know the address right off hand, but they are on the IH webring. Hooper will know, he runs the ring I hear.

http://www.lightlineofla.com/

Dana 20

Originally posted by welndmn
its so scary in here for a ford guy, but i need a blow up that hopefully lists part numbers but is not nessecery, but a blow up of the scout Dana 20 case whould work for me, or point me to somewhere that has it

Mark, Joe from Toad's wrenching weekend. Anyway I saw your post on the Fud board. I should have the part you need. Was it a rear or front output you blew. The shaft I have are only 10 spline, from a parts t-case. Let me know what sounds good to you. I won't be back in town until next week.

Joe

Thanks Hayraker,

Joe, i am trying to get the 26 spline rear output into my bronco, i wanted to see a blow cause some said the rear housing was a little different, it does not look that different, it has a litte bigger of an inside diamater but nothing that would bother me, the output are supposed to be the same size as well

here what a bronco looks like
http://www.mailordercentral.com/broncograveyard/images/TRCTCASEDIAGRAM.JPG

crossing my fingers, this should work