I tried the search and did not find what I was looking for. I saw a guy that made high steer knuckles for 44's and I can't find him now that I want some info. Does this ring a bell with any one. Also is it just as easy to get flat tops or a nother type?
Thanks for the help!

Just get flat top knuckles and spindles, search the jeep board its been talked about alot

Check on the Zuk section.:flipoff2:

On an EB make sure you have clearance for the high steer if you put the arms on top of the flat top knuckles and the tie rod on top of that you need the front bumpstops to be lowered about 3 inches to make the tie rod clear everything. If you put the tierods under the arms you are OK with about 1 inch lowered bump stops. If you just retaper the stock knuckles and put the tierod on top of those you gain a good amount of clearance with minimal problems you do have to trim the bolt for the tracbar to axle mount for clearance.

If you do a search on the Ford board under EB high steer it will come up. The only thing that you hafta worry about with putting the tie rod on top is hitting the trac-bar bolt on right turns...

Mine really pissed me off:mad3: .

Brian--

Thanks for the info, I can fab what ever needs to be done to do the swap I was more interested in all the ways people do it and pull my own opinion. Thanks again!