Alright i was wondering how to go about this, could someone gimme alink to a tech article?

I'm not sure what issue it was but, Peterson's 4Wheel&Off-Road had an article about clocking the T-case in thier Super-Duty project truck I believe it uses the same type of six bolt circular mounting pattern so, it could apply to your 208 as well. Sorry, couldn't find the issue but it was only a couple of months ago, I think.:eek:

if the pattern is the same as the dodge 208, which is the same as a jeep NP231 and Dana 300, then you could use one of these:

http://www.cjoffroad.com/D300ring.asp

the bolt circle diameter is approx 6 25/32" and the distance between one pair of holes is greater than the other 5 by about .25".

tell them jeepnmatt sent ya.

matt

thanks a bundle guys.