Anybody running of of Campbell Ent's once piece, fiberglass hood/fenders? From seeing his rigs in action, I would assume his stuff to be quality, but was just wondering from those actually running these. I'm curious as to how much, if any, they flop around at high speed.

What hoods or fenders are you talking about???? The only ones I've seen are on his new buggies. :skull:

They are basically a one piece fiberglass unit. The fenders are flat fendered, and mounted high up on the sides of the hood for tons of clearance. When I was in Farmington, tons of guys were running them. I'll try to find a pic.

ramstien is running them on grape nutz. i believe cambell gets them from 4wheelers supply who make them. i could be wrong though. tri-county has them on the yellow jeep.

Yea I knew about the 4wheelers hoods, there called "Rockcrawler hoods" There good for looks and thats about it. For one there made out of fiberglass so one little rock rubbing and the things ripped into shreds. Plus there about 350-400 bucks im pretty sure. They come with no inner fenders, aaaaand from what I understand they wont ship them. Atleast thats what they told me about when I called about 5-months ago. Hope this helps your decision. Im going with tube fenders know :D

Hmm. I was thinking about running that hood, and building some tube fender guards to run along the edge of the fenders, and connect with the radiator hoop. Sounds a little pricey though.

check out his site its www.campbellent.com the hood is in the chassis section.......:flipoff2:

How bout something like this instead....
http://www.off-road.com/rock/arca2001/farmington/day1/DSC_0050.jpg.html

these are what i'm going to shoot for when building mine not the best shot of them but the best i could find. they are on keith's rig from the rock zombies. he swares they are a pep boys special order item;) ;) :rolleyes:

The blue jeep is more what I remember his looking like. When I talked to him in Farmington, I got the impression these hood/fenders were his design, not somebody elses that he sells. Then again, it was a bit late, and I had about a dozen beers in me, so who the hell knows.:confused: :beer:

I wish they made some inner fenders for them.:(

keith built those and the design looked super easy and very clean. of course his hole jeep is setup super clean. he just had two bars bent with 90deg ends and then a bar running at a angle up to that some flat stock for mounting to the stock mounting and 18ga sheet to cover. no iner fenders though. you might try to get keith to post some beter pics of them to get a beter understanding.