custom pitman arms

[Bob]

any length, any drop, any tre or rodend configuration needed, 36 spline, can index to any position, flats (as shown) are in stock prices starting at $120

[JamisonWorkshop]

What makes are 36 spline. Can you do or is that Toyota.
I am looking for a toy 1" less drop 2" shorter.

[TRed]

I need one for a Nissan, cupled to a Chevy tre.

[Bgcj5]

I need on for a jeep cj coupled to a chevy tre, what makes are 36 spline? is is just a standard power steering spline count or is it make specific?

[Bob]

the 36 spline is a standard saginaw/jeep,chevy whatever, i can do the toyota's i'll have to check on the nissan, please call to order or for specifics, 530 626-9451

[Spawn_X]

Ok, time to order mine..

I need one that's 8 1/2"long. At the THINNER tip, where the TRE mounts for the drag link, I need a 25 degree bend (doesn't matter which direction i guess because arm can just be flipped around..). I need the bend to start about 2" from the thinner tip... so that way I would be able to put a misalignment spacer for the heim i'm using and have the spacer sit flat on the arm and not be kinked or whatever... the sharper the bend, the better.. just need 2" of "flat" at the end, then the bend as sharp as possible..

no hole needs to be drilled on the tip, just splined for a dodge ram steering box (not sure of the spline, should be standard? should be easy to find out..)..

I'm going to call you tomorrow (Thursday) to let you know (I doubt you'll see this in time...) and discuss it with you if you have any questions.

Thanks

[gotboost562]

What about one for a Jeep Cherokee. Stock drop but I would like to have the part where the TRE mounts to have a little better angle than flat like stock. What about either bending it or machining it like some of the high-steer arms are. It will be for the 1-ton TRE. Thanks.

-Mike L.

[dbunyip]

could you make one for a chevy that was clocked for a xover so I dont have to change the steering box to a 2wd?

[dieselpower]

I sent you a PM did you get it? Are you still making them? I need one real bad.
Thanks :D

[steveh]

Bob is not a computer guy. He says to call in all of his posts. Call him at his Shop, 530 626-9451, PM's and emails do not work.

I just called him spawnx, you need to do the same.

[hayabusa1]

any length, any drop, any tre or rodend configuration needed, 36 spline, can index to any position, flats (as shown) are in stock prices starting at $120

i have a question i have a 1995 gmc suburban with a 27 inch suspension lift can you build a drop pitman arm