hey, during my thanks giving break im going to be pickin up some parts from a couple of friends. im picking up a Rear Dana 60, a Front dana 44 from a F-250, 2 NP203s and a c6 auto and some other lil junk. any way how much does this stuff weigh? thanks.

you're dating the wrong women:eek:

NP203's are about 200lb (they are BIG pigs). The C6 is probably about 100-125lb with converter that is full, probably 70-80 no converter. D44 is going to be around 350-400lb if it has the thick tubes and all the parts on it. I hear about 550-600 for a complete D60 (don't have one so haven't had to move one hehe). Hope the place your picking this stuff up at has a hoist to load you. There isn"t a good way to grab a NP203. Input side doesn't stick out far enough to grab and if you try to lift it from the front output it will try to roll over on you.
If you got wheels then moving the axles is no big deal. Just roll them. I have a tilt trailer and with wheels I can load them by myself on level ground.

Ditto on the 203 weight. I can pick mine up to set it on the jack but I don't think I could get it in the bed of a pickup. :)

ok thanks. no im not going to be using a trailer, just the back of the 4 runner. haha. any way one of the 203s is on the back of the c6 and the other is just layin on the ground. thanks for the info.

The C6 is more like 140-160 with converter, at least a big block C6 is.

I don't know if a D44 is really 400 pounds, but I can assure you they are heavy. I got one into the back of my bronco on my own before, but it almost killed me.

Ditto on the 44 weight. They are heavy as hell but I don't know about 400lbs. I moved one from the back of my 22 ft deep storage unit and put it in the bed of my lifted Toyota by myself. It about killed killed me since I'm just a skinny white boy. I know I couldn't move a 400 pound anything though. I shipped a 44 rear and it was 150lbs strapped to a pallet if that helps.
Travis

I don't think a D60 is that heavy, I have a FF D60 with discs on it and it weighs in at ~350, with the full drums probably 400-450...

>I hear about 550-600 for a complete D60