here is the dana 20 e-brake - again we will offer it in the drivers side dump and pass- Jess:D

Hmmmm..... that t-case looks familar..... Jess you are just pumping out those brakes... keep it up... :D :D

Well here's the official -BIG Thanks To Mark here- Thanks man! mark helped me with the t-case here- Jess

does it work with the ten spline (I think its ten) and do you have to run the CV. How much driveline does it take up?

Very interested just want to figure it out if it will work for me.

Thanks,

arndog

What's the price, and what ya need to do to the 20?

Does this allow for a better output to be used? I know that is traditionally considered the "weakest link" in these boxes.....

looks excellent though :D :D :D

themaddhatter

Yes, very interested if it will work on Bronco D20, how much driveline does it take up, how much cost, etc etc - does it work with the stock EB D20 yoke, or gotta use yours, ???

Yep, we need the price. I'm very interested.

Damit, stop tempting me with new toys :D

Question, does the kit only work with CV style yokes? Will the brackets be available separate?

Joe

Are you using a custom output flange, or is that a spicer part? does it fit the 10 spline or 26 spline output?

Anyone know if the 10 (EB) and 26 (Jeep/Scout) spline output shafts are interchangeable? I'm ASSuming the 26-spline would be a strength upgrade for us guys with EB cases?

Chris

i should know tonight, mine should be here, and i do think its a upgrade
1. you can get them new, not 30 years old
2, mine did not really snap it twisted @ the splines then snapped

Come on Jesse, don't just post a pic with no stats. Throw us a bone on this setup!:beer: