|
The Rockslut 04-16-2003, 09:29 PM This is a 91 RC 60 front housing that is currently being centered up by 66CJDean on this board. He is putting new tube in the short side (3 1/8"x .500) and billet 9" ends. Setup to be 64" once axles are installed (not included). Has 3.54 gears with 35 spline open carrier. For an extra $100 I will toss in a near new Strange 35 spline spool. $800 Shipping is possible but prefer Northern CA. The Rockslut 04-18-2003, 06:23 AM ttt rokdog03 04-18-2003, 11:38 PM give you 800 bucks with the spool shipped to phoenix az IronBenderII 04-19-2003, 09:23 AM if it's still being made, how about making it a FF? I have a center section waiting for Dean to have time (HP) that I can give for partial trade. -Jack The Rockslut 04-19-2003, 12:02 PM It can easily be made FF. It can be made narrow and SF if wanted. The bearing ends have not yet been welded on. What do you have? Originally posted by IronBenderII if it's still being made, how about making it a FF? I have a center section waiting for Dean to have time (HP) that I can give for partial trade. -Jack IronBenderII 04-20-2003, 12:54 PM I have the HP 3rd with 4.10;s and open. The axle tubes have been cut off. Got it from Dean to be my rear end. I'm looking for full width, 35 spline, FF, no gears, carrier, etc. Axles if you've got them. -Jack The Rockslut 04-20-2003, 05:48 PM I am looking for $$$$. I am not using Dana axles in my YJ. The Rockslut 04-21-2003, 04:45 PM ttt Cheg 04-23-2003, 08:19 PM Interested. PM'd ya | |