About to start on my friends Dave's SAS on his 91 bronco using the 79 bronco D44, i am looking for write up or pics that will aid me,
eveything is going to slide in like butter', the only thing that scares me is the trac bar, so pics of how others have done it would be nice
PS i already saw Brain S. write up, he made his own top bracket, we have the top bracket drop down from the 79 and i want to use it

top eh?

Here are a couple links of a sas on an explorer which would be almost the same as the bronco

http://www.explorer4x4.com/tech_transform.html

http://photos.yahoo.com/bc/mcinchaks2/lst?.dir=/Solid+Axle&.view=t

some of the pics show the track bar setup.

Hey Mark, check out the Big Broncos website. Lots of links and write ups with pics.


www.bigbroncos.com

I hope everyone drops some good info here. :) I am going to be starting my brothers 93 in a few months.

I am planning on doing a SAS similar to what is done on IFS toyota's. Planning on switching to leaves with a Dana 60 front. Unless someone has a better idea.

He wants to run the new 37 inch boggers.
Here's a link I saved for the pics:

http://www.broncograveyard.com/products/fabritech/fabritech.html

well, really, your way sounds alot esier than what i helped my friend do on his 86 bronco. we built a subframe for the front to run chevy 6" leafs, and a D44, it sits at 19" of lift, with a 3" body lift and 42s. i have pics somewhere, but it doesnt sound like it would help you too much.
Jeff

Leaves look a lot harder to do IMO,
but i found a pic of what i wanted on that site GloNDark
I just needed a pic on the trac bar, eveythin else is going to be just about a bolt on
this guy (BTW 2g's for a kit!!!!!!!) put the trac bar on the engien cross member, wow never thought of it there
http://www.broncograveyard.com/products/fabritech/images/80fabritechft.jpg

Originally posted by welndmn
Leaves look a lot harder to do IMO,
but i found a pic of what i wanted on that site GloNDark
I just needed a pic on the trac bar, eveythin else is going to be just about a bolt on
this guy (BTW 2g's for a kit!!!!!!!) put the trac bar on the engien cross member, wow never thought of it there
http://www.broncograveyard.com/products/fabritech/images/80fabritechft.jpg

Outrageous what they want for that kit huh?? Nice stuff but DAMN!! You could build it for way less that half of what he wants. You should be fine with the Dana 44 up front too. You won't have to go too big in order to clear the pumpkin on the engine crossmember.

With the trac bar on the engine crossmember there is no way you can make it as long as the drag link.

Got bumpsteer?

COrrect, but i i make the trac bar sit about 2 inches lower then the drag link it should all work out