what would my driveshafts be like if i had a smallblock chev mated to a th350 and a 205 in a cj7? compared to a th350/dana 20 with necessary adapter?

Smaller. :D I had the TH350/NP205 setup, and I couldn't wait to get a D300 in there. The D300 is much shorter, and has a better crawl than the D20.

http://www.jeepland.net/np205d300.jpg

I have some overhead shots at home, email me if you want them...

A TH700/D300 combo would be better for crawl ratio, OD, and probably be just as long, maybe shorter, than a TH350/NP205 setup...albeit more expensive.

Bryan

well the 300 isnt an option; i have a th350 version of the 205 laying around so i thought id use it. what would me rear driveline measure with this setup?

my rear was right about 26 in. im running a 14 bolt in the rear.

i have a 465 -205 in my jeep , 14 bolt rear, 2 1/2 rancho on top of axles, rear drive is 18 1/2 inches. from bell housing to end of transfer i believe is 32 1/2 and the same for a 350- 205 combo

I have a turbo 350/np205 in a cj-7, soa+2". Rear driveline is 23" with a 9" ford rear.