|
slopoke 05-18-2003, 06:06 PM hey there, i was just wondering what the distance was from the king pin cap to the standard mounting hole for the tie rod was on a high steer arm for a dana 60 (chevy) i am going to try to mill my own so i just needed some additional info. thanks, scott CJ 05-18-2003, 06:29 PM should be the same as the CL on your pitman arm slopoke 05-18-2003, 07:15 PM well this 60 is going under my cj7 with full hydro witha 2x8 ram. Hayraker 05-18-2003, 09:16 PM Originally posted by slopoke well this 60 is going under my cj7 with full hydro witha 2x8 ram. doesn't really matter then, just put the hole where it looks good to you. I would make them about the same length as the stock arms on the knuckle. | |