I'm drunk so bear witrh ne...

my main ? is will a NP435 from a 351M bolt up to a 302?

If not what do I need to do it?

I searched and all I did was confuse myself...short shaft, long shaf....aluminum bellhousing...cast bell housing... I have a 302 and am probably getting a 435/205 from a 351M...what do I need to get to make it work...

thanks,
PSD


:usa:

I'm probably wrong, but I think all you have to do is get a nellhousing for a smallblock and bolt it up. if I am wrong I am deleting this responce and going to stand in the corner whith head hung in shame caus eI dont know shit

you need the Cast Iron bell housing from a Truck/Bronco/Econoline. 240/300 six or 302/351W will be the same. These bellhousings will use the larger 164 tooth flywheel. If you're flywheel came out of a Truck/bronco(EB or Fullsize)/Econoline will be the larger size. The smaller 157 tooth flywheel(this referes to the ring-gear tooth count) only came in cars and will be mated with the aluminum bellhousings.

The only long input shaft NP-435 that I know of came on 1965 F-100 4x4, '65/'66 F-250 4x4, '65/'66 F-350 4x2. This was an NP-435 that was mated to the 352 FE big-block. I do-not know if it is the same one used with the 240/300 I6 used in '65/'66 F-350 4x2.

Starting in 1967 they SHOULD all be short input shaft AFAIK.

Eric

Thanks Joe and Alpo....sounds like all I need then is to find a bellhousing and posssibly a flywheel depending on what it has in it...





:usa:

Search out the older Ford trucks. Any of the motors Alpo lists and about any non-auto tranny. The 435 will bolt up to where a 3 speed or 4 speed was.

You can type drunk pretty good. :flipoff2:

I gots a SB Ford bell housing for the NP435

Originally posted by desteurm
I gots a SB Ford bell housing for the NP435
Hydrolic, or mechanical??
Aluminum, or steel??

Originally posted by Rogue Bronco

Hydrolic, or mechanical??
Aluminum, or steel??

Mechanical...steel

Cant it be made to be external hydro though...

Originally posted by desteurm
I gots a SB Ford bell housing for the NP435

how much shipped to So Cal 93065?

:usa: