|
FlxnXJ 05-31-2003, 06:32 PM Has anyone welded the ford big bearing ends on their 60 to make it a SF 35 spline 60 w/o using a jig? Can you just cut the tubes off straight and weld the ford ends on, or should I have somebody with a jig for a 60 do this? I destroyed my 9":D The Rockslut 05-31-2003, 07:19 PM You need a jig to do it properly. I have a RC60 housing with Big for ends welded on that would be 63" wide with axles. Had 66CJDean on this board retube the short side with a new section of .500x3 1/8" DOM to match the other side. Old Scout 05-31-2003, 09:18 PM I built my 60 with the BB Torino style ends. The Ford motorsport 11" disk brake kit in a bolt on. Get them jigged on, the cost of custom alloys make it a necessary evil. FlxnXJ 06-01-2003, 01:58 PM Thats what I figured:D I was going to wing it if somebody else had and they had good luck, Oh well. | |