what vehicles have dana 30 non-disco axle shafts that will fit into a driverside drop 94 yj dana 30?

Cherokees, 95YJ, TJ's

Originally posted by 87YJ
95YJ

Nope!

I have a set of the one piece shaft with 297X U-joints. I go it new from drivetrain direct for $320.

Im selling them Now used for $170 with the seal need to convert a two piece shafted dana 30 to a one piece shafted dana 30.

I ran this in my 88cherokee disco d30 for about 3 years.. time to pass on the d30 parts..

$170 a little to steap for me, I'm poor broke ass wheeler.

just keep an eye out for a waggie. they are always in back yards and often ratted out and you can get them for free. then just swap the axles.

Thats how I landed my front 44.

JR

Originally posted by flexjeep
$170 a little to steap for me, I'm poor broke ass wheeler.

I don't think you'll find any less than $150. If you do you better pick up the phone.

Looks like this has turned into a "buy my parts" thread rather than trying to help you answer the question.

Just go down to your local pick and pull and start looking over the Jeeps. I'm no expert on this (as proven earlier) but the older Cherokee's with ABS typically have 297 joints and (mine came out of a '90 for $40) are a good place to look.

Originally posted by 87YJ
Looks like this has turned into a "buy my parts" thread rather than trying to help you answer the question.

Just go down to your local pick and pull and start looking over the Jeeps. I'm no expert on this (as proven earlier) but the older Cherokee's with ABS typically have 297 joints and (mine came out of a '90 for $40) are a good place to look.
Thanks for the info.:D