did a search already, but nada.

my plan is to have a Bronco arm and panhard link set-up in front, but re-use my stock rear set-up when i swap axles, just with longer links, but, the front and rear panhard rods will be going opposite directions. the rear is mounted to the frame at the passenger side and the front one will be at the frame on the drivers side. will this cause strange road handling? off-road handling? would it be better to just rebuild the rear one to go from drivers side frame to axle housing at the passender side?

thanks for info.

:smokin:

a kia?
good luck with your buildup

same as a tj

The only problem I would see is if you ever jumped it, with the panards In opposite directions it would kick the rig to the left and you'd loose controll, most likely not a problem since you most likly wont jump it:D