i was wondering if anybody had the desktop dyno that can run my specs on my engine...
its a 429 bored .060 over with 9.5 compression ..750 edelbrock carb and performer intake ..headers with 1 3/4 in primary and 2 1/2 colectors..also cam is a comp cams hydralic with .55 lift intake and .574 exhaust.. with advertised duration of 270 intake and 278 exhaust .. and duration @.050 is 226 intake and 234 exhaust.. and lobe seperation is 111.... any information is appreciated..im thinking that its a one to one engine but i dont know ..hope so ..anyways take for your time.. take it easy ..if you need any other information just email me at fordpower429@sbcglobal.net..thanks again

this is what I came up with... valve sizes were guessing off edelbrock heads, sounded about right though.

2

3

hey AZ ford thank for the reply thats what im looking for ...just trying to get some figures..Thanks again..take care