All FJ60 axle shafts are interchangable (ie. there is no difference in spline count, cut, etc.. from early model years to late), correct?

TIA.

Yes, and here is more interchange info http://www.ih8mud.com/ih8mud-facts.html

Thanks.

Course now I have to figure out another reason for why the "new" inner shaft I got from a boneyard axle doesn't seem to be fitting into place:mad:

Are they front or rear:confused:

Originally posted by Cruiserhaven
All FJ60 axle shafts are interchangable (ie. there is no difference in spline count, cut, etc.. from early model years to late), correct?

TIA.
Rear shafts...........
There is some variations, because I sent Edwin K one out of one of my parts stash, and it was too large near the bearing area to go into his.
Now it may have been an FJ62 shaft, but it would not fit in his.
Butch

Originally posted by texican

Rear shafts...........
There is some variations, because I sent Edwin K one out of one of my parts stash, and it was too large near the bearing area to go into his.
Now it may have been an FJ62 shaft, but it would not fit in his.
Butch butch do you have any fj62 front short side axels?

Originally posted by godzuki
butch do you have any fj62 front short side axels?

Short sides are the same on FJ40/60/62, so yes I should have some.....
Butch