Installing a lockright. I have no idea where the rolling pin is to remove it. Is it in the hole beneath the ring gear bolt? Just slide something in and hammer it out?

Edit: Would have searched, but I'm doing this now, and I need to get it finished up soon.

D35C?

Yes hammer the pin out, if you have any more questions search my name I just did this same thing a couple of months ago.:flipoff2:

If it's on a rear Dana 35 it probably has a threaded pin that you will have to unscrew with an allen bolt or something. If its on a Dana 30 front, it has a pressed in roll pin. The easiest way to do it for me was to remove the carrier, and pound it out with a sledge hammer and a punch. It's not too hard, but the D30 is kind of a bitch.

Even it it's on the D44, its the pin that holds the cross shaft in place. FWIW