i just moved the front axle in my CJ w/44 front by drilling new holes in the spring perches. I think that when drilling the pass side is now a 1/16" foward of the drivers side. do y'all think this will cause any handling problems or anything?
thanks
bob
p.s. where can i get a Mico-Loc Brake systeM?

:laughing: :laughing: :laughing: if its not that noticeable and doesnt look:rainbow: then fawk it but youd always have it eating at your brain that its off a little:emb:

i wish mine was only of 1/16th:D but i dont notice any trouble with mine its off more like 1/2 inch due to bent control arm mounts.

all right cool i wuz just worried it'd fawk my steering up on the road.
thanks
bob

I just welded on my spring perch on my front 44 for a SOA, I put a perch on about an inch off?? will this cause any major problems?? I dont see any off hand? Im gonna mock my drive shaft up and see if it works ok. The springs still line up so that is gonna work I dont see and major problems except Im not sure how to get a U-bolt around the casting on my front waggy 44? any help is good help. thanks:usa:

Originally posted by Jeepmangled87
I just welded on my spring perch on my front 44 for a SOA, I put a perch on about an inch off?? will this cause any major problems?? I dont see any off hand? Im gonna mock my drive shaft up and see if it works ok. The springs still line up so that is gonna work I dont see and major problems except Im not sure how to get a U-bolt around the casting on my front waggy 44? any help is good help. thanks:usa:

:D :flipoff2:

yeah like you never fawk up !!!:flipoff2: :flipoff2: :rolleyes:

my front 44 is a wagg too w/the spring over. my ubolts don't fit just right, YET. i plan on grinding some grooves in the housing to allow the u bolts to fit. on the side closest to the diff i plan using a square "U" bolt. i've actually got some on it like this now but they don't fit as well as i wish so i'm gonna groove them. If it works i'll take a pic and send it to ya.
Later
bob