I need to know the length of an f-250 full floating dana 60 axle shaft. I'm doind a 60 swap in my wrangler and need to know this info. Your help is appreicated!

OR, if you happen to know this... What is the width of an axle housing with 36" long full floating shafts?

both sides are 36 inch??? or just one side!

because i found dana 60 from a f250 35 inch'es long axleshafts on each side it was 65 inches WMS toWMS so i would say 67 or depending on the hub offset!

where are you measuring?? take the measurement from the end of the splines to the inside of the flange that bolts onto the hub .


what is it there or is that what you are measuring from!

So many different offsets on the hub WMS to tell.