I went to bolt my 1350 u-joint to the yoke on my 14 the other day.... but the distance between the end tangs on the yoke are about 1/16" too wide to center the joint.

It's not big enough to be a 1410 series.... is there a Chevy/GM yoke that has a ~1-1/8" cap with slightly less than 4" overall width?

3R Joint???

What's that, and can I get a crossover joint to match it?

I measure roughly 1-3/16" x 3-11/16"

the tangs get work causing end play -your yoke is junk- i see this alot your not special-jess:D

Thanks man. That solves that problem. :D