I have a specific question about my application. My axles for my truck are built already. I have an 82 j10. Stock front D44 is 65" wide, rear amc20 is like63.5". New axles are StockD44 front with 3/4 ton chevy outers 67" wide, and 14 bolt rear 67" wide. I am now addressing tires and rims. I have a line on a set of 36" bias hummer tires a co-worker will trade me for my 35s(15" rim) even across. If I use a 16.5 hummer rim the bolt pattern will match up, and will work with the new tires, and be CHEAP , and possibly give me a beadlock (and be somewhat inconspicuous to the local law inforcement) if I get the right application.Will these rims fit in front with this severe backspacing, without spacers??? (my outers are flatops, cutoff stock tie rod connections, and bob roggy high steer arms 1-1 1/8" thick with a 1" rise, and appear to be turned inward slightly more than the stock width, and obviously in a much higher location). I think the stock backspacin is like 4" with the 15X8 rim, additional width comes in with 3/4 ton outers(just a shy under 1" additional on each side). HELP, do not want to buy rims if they won't work!!!???:confused: :confused:

The bias military two piece hummer rims I have, got a 7.75-8" backspacing. They will interfer with the stock steering arm and highsteer arms unless made to clear them. If you need any measurements I can grab to tape measure.

i believe thay would put your stance too narrow for a j-truck.

i'm running a J-20 dana 44 with flat-top knuckles and a hi-steer arm myself, and Hummer wheels won't fit mine.....
i'm getting some 1 1/4" spacers made myself. here ís a pic of test fitting the hummer wheels, they have 1/2"or so of washers on the studs before the wheels (the calipers have been ground some also) and they still contact the knuckles. but the brake rotors are very well protected :rolleyes:

http://bbs.off-road.com/wwwthreads_uploads/53-618968-hummertestfit1.jpghttp://bbs.off-road.com/wwwthreads_uploads/53-618970-hummertestfit3.jpg