Here is what I got off the Dana Spicer web page, I think all the dimentions are right for a 205, can I just get verification?

http://a2.cpimg.com/image/C6/CC/24250822-0708-0200010C-.jpg
D)1.188
E)4.438
OD of splines: 1.3750
Number of teeth: 32 I
R) Ground Hub Diameter: 1.886
Q) Lenth Thru hole: 2.000
S) C/L to end of hub: 3.6750
Joint angle: 0
Style: BS
Part # 3-4-13511-1

JYS

that part # is actually 3-4-10951-1x strap style only but we convert these to u-bolt - just a friendly cost 69.00 $ with u bolts- Jess

look at the ~90-93 dodge cummins application for a rear 1410 yoke for a cross reference

my catalogue is too old to run it to check

I have the dodge part number, I just didn't know where to cross reference it at.

JYS

slightly offtopic...


i've ben looking on Dana's site for dimentions of their yokes (specificaly the 1310 and the 1350) and i've been unsuccesfull, can you post the link please?

thanks!

http://www2.dana.com/expert/

Go to Identify Part by Dimension , then End yokes , then Splined (all others) , then select the series (1310 or 1350).

It is pretty easy to find part numbers if you have all the dimensions, but there are a lot of 'Almost right parts' if you don't have every mesurement (for example I thought I had the right part number, had Jess not spoken I would have had the wrong yoke!)

damnit Junkyard Slug, you deserve a beer!


thanks for the link/info :D