Hiya Cruisers-

Here is another item that I'am tackling on my "things to do list".

I noticed that each time I depress my clutch, I noticed a little bit of brake fluid coming out of the rubber boot and dripping on to my floor board.

How can I rectify the problem? Would changing the boot solve the problem or would I need to remove the entire cylinder?

This is the rig that I'm learning about engines and stuff, so any info in laymans terms would be greatly appreciated.

I love my cruiser, she will be my never ending project, but it seems that her project is to drain my bank account faster than I can put anything in it.

Happy Cruzin Everyone

I rebuilt mine cause of that problem and cause it was time any ways since it had never been done. Doesnt leak any more. rebuild kit is cheap from specter off road. www.sor.com (http://www.sor.com) is their adress case you dont have it.
where in WA u at? im just teaching myself everything so far too for cruiser. we should get a little newbie cruzin goin on
ben
71 fj55

Hiya SwampPig-

Thanks for the info, I will look into it.

Also, was it a pain to replace it? I'am basically mechanically challeged and is wanting to learn how to slowly be unchallenged.

I just live a stones throw aways from ya.

I live in Kirkland.

[ 10-08-2001: Message edited by: Ruff Ryda ]

[ 10-08-2001: Message edited by: Ruff Ryda ]

i chanbged mine its easy. 3 bolts and the pin holding it to the pedal. then remove the lines and when its back together and the new ones in ya gotta bleed it. not a big deal.

Rebuild both master and slave cylinder as you will soon blow out the slave if you don't. Good time to replace the clutch hose, too.

heya you really are close im out by woodinville and duvall. I had no prob putting it in. as DCruiser138 said its some bolts a pin and thats it. If you want i could give you a hand, its really no big deal to do it. I think i even have a spare rebuild kit. Ill check if i do. gieve me a email at PwdrBorder@hotmail.com
ben