Toyoda
10-23-2003, 10:04 PM
The drums won't let go. The shafts are out of the axle housing. It is a toy rear. tried taping the studs and the drum itself, also tried droping it on the studs. any good ideas?
|
: how to remove the brake drum when it won't let go. Toyoda 10-23-2003, 10:04 PM The drums won't let go. The shafts are out of the axle housing. It is a toy rear. tried taping the studs and the drum itself, also tried droping it on the studs. any good ideas? larryboy 10-23-2003, 10:08 PM pry it away from the backing plate while tapping at the same time. before that soak it in pb blaster and work on it tomorrow. Pazuzu 10-23-2003, 10:24 PM Originally posted by Toyoda also tried droping it on the studs. any good ideas? I assume you had the lug nuts on the studs when you did it, right? :D Do it again. Put wood on the ground and nail it three times. It'll pop off... waverider 10-24-2003, 01:35 AM try using the two empty holes in the drum, they are there so you can run a bolt in each one and they will pry the drum off of there for you. I forget the actual size thread, but I think they are in the neighborhood of 6x1.00 mm. kcpsg 10-24-2003, 05:10 PM put a little heat on it w/ a torch and use a BFH :D P&T Jeeps 10-24-2003, 05:12 PM yup, BFH! :D Toyoda 10-24-2003, 06:40 PM I finally got the drums off. used some bolts. reeser 10-24-2003, 06:55 PM Originally posted by P&T Jeeps_ yup, BFH! :D BFH definitely!:flipoff2: Arnold 10-24-2003, 07:58 PM Originally posted by waverider try using the two empty holes in the drum, they are there so you can run a bolt in each one and they will pry the drum off of there for you. I forget the actual size thread, but I think they are in the neighborhood of 6x1.00 mm. IIRC, they're 8x1.25 mm.:) TaterCrawlin 10-24-2003, 09:22 PM give it a little tlc with a BFH rockcrawler304 10-24-2003, 09:42 PM Hey guys....He got the drum off!!! :flipoff2: P&T Jeeps 10-25-2003, 12:17 AM Originally posted by rockcrawler304 Hey guys....He got the drum off!!! :flipoff2: so what, BFH's are fun and cool........ :flipoff2: :flipoff2: :flipoff2: mikesimpson 10-25-2003, 06:55 PM BFH!! BFH!! BFH!!BFH!! BFH!! BFH!! BFH!! BFH!! BFH!! :D :D :D :D :D :D :D :D :D :D Peabody 10-26-2003, 12:02 AM LOL You can take just about anything in life apart with a BFH and a torch. Duct tape and bailing wire to put it back together. animator 10-26-2003, 01:10 AM Originally posted by Peabody LOL You can take just about anything in life apart with a BFH and a torch. Duct tape and bailing wire to put it back together. :laughing: I used a grinder and a BFH to remove a wheel bearing that was fucked up. Come to think of it, that's how I got my old pitman arm off of my tie rod too :D | |