we decided to make some up for a buddie and me last night
http://bbs.off-road.com/wwwthreads_uploads/53-622719-beadlock1fixed.jpg
http://bbs.off-road.com/wwwthreads_uploads/53-622727-beadlock2fixed.jpg
and i am not building anymore if you want some get them from scott at rockstomper.com. we just built a couple of sets for ourselfs. i used 3/16 cold rolled steel with a 36 bolt pattern. and i used 8mm press nuts. scotts are tougher in thickness and bigger bolts. i think these should work fine for me. god its great to have a 1/2 million dollar laser at my work. but my total cost was zip so i am tickled shitless. just used some scrap plate we had. mike

and just remember scott copying is the best compliment. yes it was a shamless copy mike

do you have at work?

Amada?

:nuke: :nuke:

DAMN MIKE,

We have got to hook up!!

Nice work, :smokin:

Mike, dude, have I told you lately that you suck?? If not.........YOU SUCK!!!!!!!!!!!!! :flipoff2: :flipoff2:

I am going to hook up with my Father in law and make a set for myself. Should be interesting!! Any advice??

its a amada about two years old. sweet machine will do 3/8s but it takes to long. it took 9 mins to cut out each ring. so we played pinball on the puter then put in the press nuts. they were easy with the right tools. now i have to find another set of 15x10s to weld these on to.

hey glowndark i can't really give any advise because i havn't installed them yet so i have no idea what i might run into. mike

Nice Frisbee's!

mike you are one luckey sob!