what is the cheapest way to go and where to go..?? I have seen 2 differant ways of doing it.. One way I saw was using the tie rod that is also the tie rod end too.. and one has removeable end on both sides.. Oh yea,, I already have my arms so I am just looking for tierod, draglink, and ends..

Check out my article:

http://billavista.tripod.com/Steering/Research/steeringresearch.html

thanks, alot of good info.. is the es2233l and ES2234r the same taper as the 3/4 ton and one ton?

I dunno if this info helps, and its not hi-steer, BUT...

http://home.off-road.com/~bibelheimer/sas.html

Originally posted by BillaVista
Check out my article:

http://billavista.tripod.com/Steering/Research/steeringresearch.html

Damn, Bill that really is a very comprehensive site.
I like how well you listed all of the parts even for such things as the Ford 5 on 5 1/2" swap. Very impressive.
And it even has a couple pics of my Junk in it:D
I have decided to use Erics rear tie rod arms, since Im gonna keep the D44 for a little longer.
I think the rear arms will have to be the newest addition to your site.
Again, very cool of you compile all that info for everyone to use.
Sweeeet site.

Thanks all for the kind words....

And mostly thanks for the tech info....Keep it coming and I'll keep bunging it up on the page.....

next are the rear tie rod and the sources for jam nuts in 7/8-18


It never stops...........I love it.

H8 - glad to hear the 44 is staying......man, I hope CTM gives you a cut, I know you've been quoted all over the place and there's a LOAD of excitement about these due to your thrashing and reports!

Happy Holidays,

Do both the ES2234R and the 33L come with Jam nuts?

Also Scott at Rockstomper can make the Jam nuts. 'course mine apparently got lost in the mail. Twice. :rolleyes:

Other than that. he is a great source for the custom 'rods and a good help with selecting parts.

Rick Boiros

thanks, alot of good info.. is the es2233l and ES2234r the same taper as the 3/4 ton and one ton?

same taper different depth, i am fighting that right now.
cant find a reamer that goes deep enough.
same size as tie rod ends but not same size as draglink ends