|
BillyBob535 12-21-2001, 01:18 PM I bought a pair of axles from a 4cy YJ (4.10 gears) to replace my aging set (with 3.07's). I noticed that the place that should have the spot to put the vent hose has no fitting, in fact it seems to be just a hole in the housing. Anybody know what I should do about this (besides get a D44) problem? I have the 4x4 posilock which provides a spot for a vent plug and I was thinking of using that and plugging the factory hole. Suggestions? Thanks. WillYJ 12-21-2001, 02:03 PM I'd try to remove the fitting off of you current axle, and put it on the new one. Either that or put a new fitting in. :usa: SniperFire 12-21-2001, 04:40 PM You could tap it and put in an air fitting eh? WideJ 12-21-2001, 06:22 PM I agree with sniperfire, the best thing to do would be to find a new fitting, tap the hole, and you're good to go! BillyBob535 12-22-2001, 04:36 PM Thanks. tj_chick 12-22-2001, 09:53 PM Originally posted by BillyBob535 I bought a pair of axles from a 4cy YJ (4.10 gears) to replace my aging set (with 3.07's). I noticed that the place that should have the spot to put the vent hose has no fitting, in fact it seems to be just a hole in the housing. Anybody know what I should do about this (besides get a D44) problem? Thanks. Get a 60 :flipoff2: fawkin newbie | |