PDA

: th350 to 700r4

burris1204
12-23-2003, 02:04 AM
looking for info about swapping a th350 out for a 700r4 in a 76 K5 with a 203 transfer case. specifically if i needed to swap the output shafts for the drivelines. any help is greatly appriciated
BEAR
12-23-2003, 08:31 AM
The spline output and diamiter are the same on both, the 700's mane shaft is a bit longer and will need to be cut a little off the tail end.
They use the same adapter but the 700 is a longer trans so you will have to move around the crossmember and adjust the drivelines.
thundr undrgrond
12-23-2003, 10:30 PM
why keep the 203, the 208 that would be on the 700 is a way better case, lower low range, not full time, lighter. ditch the 203 with the 350
burris1204
12-24-2003, 04:45 AM
unfortunately im only getting the transmission so for now I have to keep the 203.... but hey you can't pass up a free tranny now can ya???
NoBrainR
12-24-2003, 11:42 AM
Keep the 203. That's the first step towards an ORD doubler. Keep an eye out for a 205.

http://www.offroaddesign.com
SCOTTS_4X
12-24-2003, 03:11 PM
Originally posted by NoBrainR
Keep the 203. That's the first step towards an ORD doubler. Keep an eye out for a 205.

http://www.offroaddesign.com

or you could support the board and buy one in the vendors section from john351c for half the price of an ORD adaptor ;)

-Scott
NoBrainR
12-25-2003, 06:41 AM
Originally posted by SCOTTS_4X


or you could support the board and buy one in the vendors section from john351c for half the price of an ORD adaptor ;)

-Scott

I guess I thought that funny yellow star by Stephen's name means that he is a vendor who supports the PBB. :rolleyes: