Anyone have experience using them in comparison to competitors?

What material do they use? Is there anything better with a limit of 35 spline? This is what I am looking at mainly.

I need odd ball lengths (everything rover is odd ball :mad2: )

Are they really only $295 a pair?

Thanks
Ron

I HAVE THEM IN MY CRUZAH D60REAR.....I HAVNT HAD ANY PROBS....YES THEY ARE 295 PAIR.......

Buy them.. Thats what I am getting eventulally

I have Moser Front D60 Shafts in my rig.
Yes $295/pr is right and they fit perfectly. BUT you should know that they are Spicer blanks that they cut and spline. They currently don't make their own D60F shafts, so there are no upgrade in strength.
I am very please with my shafts and I recommend them to anyone.
Just my $.02
B

60F alloy shafts are due out soon. Thats what they tell me. I would say about March is the latest impression I got. I need them bad.:(

call CTM see if you can get some 300m shafts......

Sorry, CTM DOESN'T make alloy shafts! Yes I've read the articles. I have e-mail them and they referred me to Moser.

HE DOES MAKE FULL FLOAT 35 SPLINE SHAFTS OUT OF 300M.... oops caps, but he is super busy with the joints he may have put the shafts on hold... at least that is what i gathered from him when i spoke to him on tuesday while ordering my joints......

I wish he did. I'm waiting for alloy shafts so that way I can run them with the CTM joints. Hopefully after that I won't have to go into the rearend for a long time.:)

Ok that sucks.

I was looking for something like Hy tuff or at least EN 25 or EN 26. Forgive the lingo if you are not familiar with it. EN is european specs, Hy tuff is what maxidrive uses (rover). but they don't make 35 splines for the salisbury (rover D60).

Soooooooooo

where do I get the best material axle shafts for a D60 in custom lengths? And what is it going to cost me? I can get EN 25 35 splines from McNamera but I really what the highest spec possible.

Ron