I did search...without much luck.

I have a 30 spline rear full float D60. I wanted to convert it to 35 spline but realized the 35 spline axleshafts won't fit through the spindles...any suggestions? Or should I just ditch the 60 and go with a 14 bolt?

Dan

No, its not possible:rolleyes:

Search!!


Ok fine, if you really want to you can take it to a machine shop and bore out the spindles, or cut off the ends and put 14 bolt ends off, or go get a 60 from a van like I did that has spindles big enough already:flipoff2:

nope. 100% impossible, sorry. http://prod.bsis.bellsouth.net/coDataImages/p/Groups/23/23544/folders/104047/828873asshat2.gif

Try the newbie section. Great advice in there.:flipoff2:

Thanks for all the highly intelligent answers...so much good tech here...I know it is possible to bore out the spindles and or swap the outers, basically I just was wondering what other people have done. But I guess I should no better than to ask a question because ALL the answers already exist under the search function.

thanks again

Dan