: 60, 70, and 38.5x11.00x16 boggers sale


loco.eng.
01-13-2004, 04:06 PM
fonrt 60 bom#610057-6 chevy dually 4.10 open and still uncut and stock. the -6 part of bom does not show up on dana site, but the rest of the bom is right-on.
rear 70 4.88, detroit and right width for k-5. i do not know the bom on this one but as for the width, it is under a k-5 now and looks right at home,ie full width and un-cut.
the tires are BRAND NEW never even been bolted up. they are mounted on 96 chevy eight lug stock steel wheels and there are 5 of them.
for the 60 i have a detriot locker for 4.88's, 4.88 gear from randy's, minor install kit for gear, single rear wheel hubs and 35 spline outer kit w/ warn premium lock outs from 4wd factory, new calipers, pads, and caliper hardware. all of the above parts for the 60 are BRAND NEW and still in box.


$900.00 for tires

$750.00 for 70

$1950.00 for 60 w/ all new parts, will NOT separate the 60 stuff

i WILL NOT SHIP any of these items, but i would work with a guy by meeting somewhere at buyers expense. we'll talk...

due to my work schedule, icannot be at the computer every night, so if i don't respond right away, be patient.

i am located in south central indiana.

loco.eng.
01-13-2004, 07:38 PM
ttt

bb93yj
01-13-2004, 10:45 PM
Sorry work schedule, must be on the extra board, huh?
Wish you were closer with that D60, just what I need for my project...

-ex UP hogger

loco.eng.
01-13-2004, 10:48 PM
i live for csx

bb93yj
01-14-2004, 08:10 AM
HA! I know exactly what you mean. (25 years of their crap, four mergers...)

GubNi
01-14-2004, 10:30 AM
I need that rear axle. But shipping to East TN?:confused: Is it a 70HD? Is the pinion centered in the axle? Sometimes they are to the pass side an inch or two.

Kreep
01-14-2004, 11:06 AM
Would you consider selling just one tire? I'm looking for a spare.

If so, could you lay it on the floor, put a board across it and measure the overall height and width? I need to figure out how to fit it behind the rear seat...

I might be down your way in Feb for the IFWDA meeting at French Lick, I could pick it up then.

loco.eng.
01-14-2004, 04:23 PM
gubni, i don't know if it is an HD or not and the pinion looks like it is dead center to me and i e mailed you after the pm Kreep, i hate to break the set just yet because if this stuff does not move, i'll end up using it. but, fyi, they measure 37" tall and 13.5" wide w/ 30# of air and no load on them. randy

Kreep
01-15-2004, 11:23 AM
Thanks for the measurements. I assume that's a 6" wheel?

bump for ya!

loco.eng.
01-16-2004, 09:58 AM
offers??????

loco.eng.
01-17-2004, 12:42 PM
bb93yj I pm'd you.

bb93yj
01-23-2004, 06:00 PM
Sent ya one back...

SlowmoSU
01-29-2004, 05:15 AM
Still got this stuff ?
and willing to ship ?

PM me, thanks