hey guys, i have a Electric BW1356 on its last legs(chain is waaaay to streched, clunks bad when i get off the gas) well anyways since its bad im just goin to convert to manual controll anyways. i found a good tcase from a f350. its a manual shift BW1356 with a PTO hookup. but theres a conflict, this case has a tail exstenion on it and as short of a wheelbase that my FS bronco is anyways, i doubt the extra 6" wouldnt be good. now my question is, can i just take the output shaft off my current BW electic shift and put it inplace of the exstended one then swap endcovers? i know the covers the same, i just dont know if the electric setup has the same shaft setup. thanks in advance!