I talked to Axle Jack today from CTM Racing (http://www.ctmracing.com). He is sending out my CTM D44 ujoints today. :bounce::bounce2::bounce: I will be doing a full write up on these 'joints including installation, side by side comparison to 5-297x/5-760x Spicer joints, and then putting them through hell in my rig. Stay tuned!

wow install too! :p

Cool deal, i just really want to see the pic of the CTM vs 297 vs 760 all laid out

Take it from me, theres no comparison..

The ones in nasviks front end are HUGH!!

HUGH? Umm.... HUGE? :D

Lance, you're such a follower. You shoulda had these a long time ago. :flipoff2:

Paul

Originally posted by nasvik

Lance, you're such a follower. You shoulda had these a long time ago. :flipoff2:

Paul

I know, but Im not as good at BJ's as you. :rainbow: :flipoff2:

Woohoo! Can't wait to torture these mo-fo's! :bounce::bounce2::bounce:

mine should of been here today, but with the holidays im hoping for monday........

just remember dont open the rings too wide when installing the will loose some of there tension if you do....... Jack reminded me of that a couple times......

Originally posted by Lance


I know, but Im not as good at BJ's as you. :rainbow: :flipoff2:

Woohoo! Can't wait to torture these mo-fo's! :bounce::bounce2::bounce:


Hahahaha, Yeah, but the bad tatste:barf: goes away after a few beers,:beer: and then you have strong U joints :flipoff2:

Put the whoop to those joints, Lance!!