Well, I cut my stock skid and raised it 2 3/4". The stock skid is cardboard, but it raised it up higher. I'm building my own skid that is 3/16" and will sit in the same raised position.
I've got a picture I'll put on in a few minutes, just have to wait for my ftp server to get back online.

http://www.xmission.com/~sk8zero/raisedskid.jpg

Man,
You gained alot of clearance on that fawker :D

more people should raise their tanks to show off their dana35's:flipoff2:

what size body lift is that?

Originally posted by high5
more people should raise their tanks to show off their dana35's:flipoff2:

I was gonna comment on that too, but showed some restraint :D

i had to! :flipoff2: the raised tank does look good though. lots of added clearance.:D

hey Newbie...(sk8zero)

Where is the wrightup on that lift? How did you do it?
How much room did you loose inside? ComeAWWN

a nice job like that needs more attention.. more pics..

Or is it on your website which i havn't seen yet...:zzz:

hell yea... tell more!

I was somewhat hesitant in showing the D35. You know how it is when your a Neuroscience major getting ready to enter Medical school. You don't have the money to spend on a D60 or a High 9" at that point in your life. :flipoff2:
Sorry, as of yet, no write ups on how it was done. I've been too busy with the holiday break. You know how it is when you've got friends who are sponsered by snowboard and skateboard companies!? Snowboarding, snowskating, and skateboarding all take precedence over anything else during the holiday break!! :D

Thats fine, just make sure it gets here. Please...

looks good. I opted to go this route but decided to just go with an aluminum fuel cell :D Im hoping it gets here soon its been on back order for over a month. They said it was going to ship on the 28th. I'll post some pics after I get it installed :D