I'm going to have a friend build me a winch bumper but I just don't know what I want it to look like, the only thing that I have determined is that I don't want it sticking out in front of my truck a mile.
Anyone have pics of their bumpers they could post would be great.
Thanks in advance.

My bumper sticks out only about 1.5 inches farther than a factory bumper with the bumperet uprights. It's built to accept a Warn 9500i or a other warns in that same configuration. It is set up to use Clevis's and has a reciver if needed. Works great for worming my trailer into tight places. It can also be set up to be air tanks. Nice and flat and wide on top so you can stand on it to get at the engine. More pics in the link in my sig. Your welcome to use any ideas.
http://www.gbr4wd.com/profilepages/HummerlEric/Dscn0754.jpg

get ahold of Burt4x4 on coloradok5....he lives in modesto...he has a nice winch
bumper on his 72 blazer...i think its made my KMA but it could easily be copied

Chaz

I know there are more winch bumpers than these two, please show me more I need more ideas!!!!!!

RCG, in my webshots album is pics of my KMA wincher bumper. I havent saved the $$ to get my winch yet, but the bump has otherwise served me well so far. Check it out at...

http://community.webshots.com/user/jekbrown

have questions? lemme know,

J

This is the Warn Classic bumper - lots will say they suck but they don't...........the sides are not the most robust in the world but that strength only matters if you are mashing the bumper into rocks or trees I guess . The center section is very strong, holds an M1200 Warn winch easily. Sticks out about 3 inches further than the stock bumper 'bumperette's' did............:Dhttp://www.blazzinor.rockcrawler.com/images/one_ton_project_d60_from_the_front.jpg