ok guys, i have looked EVERYWHERE i can think of down here and can't find what i need at all! i need a FORD 4speed bellhousing and flywheel to bolt my 302 and t18 together. i also need ALL the other clutch stuff go w/ it. does anybody know of a good Junk Yard that could quite possibly have this stuff and is willing to ship?

i've tried the 'WANTED' section, w/ no luck. so, i figured i'd ask here.


-russel :D

I don't read the want adds as much as I Should becouse I have 3 that may work for you . 3 bells and 2 flyweels and as for the linkage it depends what your trying to fit. email me if you are intrested at mcgyver1965@yahoo.com

still looking guys. i need this stuff from an 80's f series truck. my motor is a '91. i know somebody out there has what i need!!! PLEASE HELP! :confused: :confused:

thanks alot -

russel

I have two aluminum hydraulic bellhousings with the small block patter...they were both mated to NP-435's but I think they use the same pattern and depth as the Ford T-18. Anyone know fo sure?
I could prob ship one of em' if you can't find it closer

As for the flywheel I would just go down to your local Autozone/Kragen and buy a new one. I just bought a reman'd one for my 460 because it was only $35.99. I couldn't even have re-surfaced and put a new ring rear on my old one for that much. It did have a $90 core charge, but I just gave em' an old junk flywheel I had layin' around.

i would definately be interested. the only problem i would have would be making a hydraulic setup. mgyver gave me some suggestions, but i think it's still going to be tough. reply back here or emial me and we'll work out the details. i will try and get back to you tongiht. thanks alot- russel

olivesman@4wheeloffroad.com

btt


hey FORD POWER- your email doesn't seem to be working. i am still interested in one of yourbellhousings. thanks- russel

not sure if ya got my PM or not....Anyway on the dydraulic setup all ya should have to do it go down to the parts store/junkyard, and get a clutch master and slave cylinder, I think there about $30 each.

I have an extra from a EB (a bell housing was a bell housing from ford unless it was a hydro)
It has the fork and that crap on it as well, fits bengid a 302 and NP435