for d44 flat top nuckles...I saw them somewhere but can't remember...

the part numbers are:

Studs/washers:
Stud-3965137
Washer-3965138
Nut-9442950


Only avalible at GM..

Steve

I think a stud extractor and a trip to the pick N pull is less expensive then the GM dealer :D

Steve thanks for the Part numbers though I might just find myself to buy the extractor and then drive to Stockton:D

Todd you disappoint me..

I thought you were a true redneck, Two nuts and two wrenches..

No worries on the part numbers. remeber I am doing this also..

Oh believe me I've done that.
thats how I got three of the studs that I have :D

It was a hot 95 degree day at the pick N pull and I spent an hour and a half getting the drag link off, the cone washers off and then the three studs.

Not Fun at all.

Have I restored my polish redneck reputation amongst yall :D

thanks for the help

are those studs 9/16-18 top and bottom. I've lost mine, but I need shorter ones and finding a fine thread 9/16 anything is difficult around here. I'll end up ordering them from a fastener place but I need to know if it's the same thread on the bottom.

Easy

Yes, 9/16-18 (fine thread) top and bottom. Good luck finding them anywhere other than the GM dealer or junkyard. They probably won't be available from the fastener house.

hey, at the dealership, they don't call them "conic washers," they call them "spacers." Just so ya know...