Hey Shane or anyone else.... Who are you getting your DOM tubing from in the Sacramento area?:confused:

i get mine from (delpaso pipe&steel)

Originally posted by Non Urban
Hey Shane or anyone else.... Who are you getting your DOM tubing from in the Sacramento area?:confused:

Man you are DUMB!!! :rolleyes: They get it from a STORE!! :flipoff2:

Originally posted by NC Zuk


Man you are DUMB!!! :rolleyes: They get it from a STORE!! :flipoff2:
Ummmm :flipoff2:

I'm getting prices like $6-$7 per foot down in the Stockton/Modesto area. Is that about the going rate?

Adam Ant and I usually buy ours together.....We are usually able to buy deeper that way:D

I would say Del Paso, or ABC would be your best bet...

What all do you need? I may have some:D

Originally posted by Rudezuk
Adam Ant and I usually buy ours together.....We are usually able to buy deeper that way:D

I would say Del Paso, or ABC would be your best bet...

What all do you need? I may have some:D

I need 1 1/4 ID -1/4 wall, or even 3/16 wall will work. It's for my coil conversion. About 30 feet.

tube is by O.D. not I.D. or are you looking at getting pipe

:massey:

Originally posted by Non Urban


I need 1 1/4 ID -1/4 wall, or even 3/16 wall will work. It's for my coil conversion. About 30 feet.

1 1/4 ID -1/4 wall = 1 3/4" OD :flipoff2:

then thatz what he should have asked for because if he calls a place and asks for that he will get pipe




:massey:

Originally posted by Shrock
1 1/4 ID -1/4 wall = 1 3/4" OD :flipoff2:

i second abc supply they are really good people that know what they are doing.

-rudezuk, did adam ant ever get his straight axle conv done on the tow rig?

All I'm concerned with is the ID. That has to be 1 1/4. I'll look into ABC and DelPaso. Thanks all

Dude,
I'm guessing 1 3/4 " x .250 wall is going to be your links, and your matching the ID to thread or fit tube adapters into? Thats going to be huge links for a sammi. Just a sugestion, I'd use 1 1/2" x .250 wall and drill and tap for 1" threads. The 1 1/2" is easier to find and cheaper.
Pepdaddy

Originally posted by pepdaddy
Dude,
I'm guessing 1 3/4 " x .250 wall is going to be your links, and your matching the ID to thread or fit tube adapters into? Thats going to be huge links for a sammi. Just a sugestion, I'd use 1 1/2" x .250 wall and drill and tap for 1" threads. The 1 1/2" is easier to find and cheaper.
Pepdaddy

Not a bad idea. Thanks. Actually I am taking 7/8 coupling nuts and milling then round to 1 1/4 and putting them in the ends. The threaded stock will be welded on one end. The other will remain free to swivel. This eliminates the need for Heim or Johnny Joints. Very similar to the links from TeraFlex.