What wires is everyone using/recommend for HEI and low rpm torquer?

Personaly I like Accel cut to fit wires. Inexspensive and I have been using them for years and years on all of my rigs.
No need to pay insane amounts of money on wires.
I have thought about the MSD ones but for $80+ I just can't justify that cost on a stock HEI system.
I think that a set of Accel cut to fit wires are about $25.
I use the 8mm ones with the Accel Super coil on all 3 of my rigs.
Yeah ya have to cut them to length but it makes for a much neater installation esspecialy if ya have looms.
It takes me about 30 minutes to fit, cut and install 8 wires.
http://images.freepichosting.com/2002-0-3-4-12-33-0225.jpg
This is the 463 in the 73, kinda crappy pic but ya get the idea

Mallory,MSD,Jacob's all have very nice wire sets.Its nice to hear that some one is having good luck with accel,I realy haven't been to impressed with them.

I ended up trying the Heli Core MSDs'... The nice thing was i got the 8 cylinder version for my inline6. I did all the wire cutting to as small as possible and i now have a good three sets of wires which should last me a lifetime.

The universal sets have extra long wires- so if you have a short wire setup- you could get a good 2-3 sets out of it easy.