|
Alaskan Assassin 01-03-2002, 12:59 AM http://www.bigjeeps.alloffroad.com/images/dana_60axle.jpg Here is a picture of my high pinion 60 that has been cut down to about 64"es mounting surface to mounting surface, it has 4:56 gears and a lock rite:) hope yah like! Alaskan Assassin 01-03-2002, 01:01 AM http://www.bigjeeps.alloffroad.com/images/60.jpg Here another.... High5 01-03-2002, 01:41 AM sweet!!!:D RoCkSkuLLz 01-03-2002, 09:51 AM Nice 60 :D Now remember my mailing address is 4080 lem... :D Alaskan Assassin 01-03-2002, 10:00 AM I think I am going to keep this one RockBuggy:D But hey you can have my dana 30... You want:D J/k Thanks for the reply's! m715 01-03-2002, 01:13 PM Lookin good! What kind of transfercase are you going to run with the drivers side drop? Alaskan Assassin 01-03-2002, 01:28 PM In there right now is a Dana 20 out of a early bronco that is adapted to a NP435. Works well..... 66CJdean 01-03-2002, 03:48 PM Looks purdy:flipoff2: Good job. H8monday 01-03-2002, 03:59 PM Lookin good. That driver side drop and all sure would like good under my rig. Even the width is right on. Nice work. wheelinjp 01-03-2002, 04:52 PM Hey nice lookin axle man. I am curious is it cheaper up there in the land of the one ton to find a cheap dana 60? Karl Andraschko 01-03-2002, 05:57 PM What center section did you use? Looks like a nice job, bet you can't wait to wind it up... Alaskan Assassin 01-03-2002, 11:37 PM Thanks for the reply's! Wheelinjp you will probley laughat what I bought my axles for but here it is. I got the 79 Ford and he HP60 front and the 60 rear for $140.00.:D As far as what center section it is a regular Ford 79 F-250 High Pinion 60. I just cut it down... Again Thanks for the REPLY's! AGGIECJ-7 01-03-2002, 11:45 PM looks good...how much do you have in the axle besides the initial cost of the axles? did you do all the work yourself? Alaskan Assassin 01-04-2002, 11:10 AM Well right now just in the front I have $700 and that is just in the locker,gears and the set up kit for the gears. I still haft to buy stub shafts, and spindel bearings, and a lot of little stuff. I estimate just in the front there will be over $1000.00.... Wheelr 01-04-2002, 11:21 AM Nice, but my 30 has more ground clearance :rolleyes: :flipoff2: | |