OK, I'm sure this has been gone over a million times, but my search turned up nothing! I suck at searching anyway.

I have a 1976 350 and was wanting to put a TBI setup from a newer motor on it. Is this possible? What should I be looking for in a donor setup?

The motor is recently rebuilt with a 10.25:1 compression ratio. I don't think it puts out more than 300 hp, but it could. I don't know for sure since it's never been dynoed and have not driven it yet.

J. J.

it is possible but you need all of the sensors and an engine control module from a donor truck. Wiring harnesses are necessary also. Might be easier just to get a kit from Edelbrock or a Holley ProJection kit

I'm not worried about easy. I'm worried about $$$! :(

J. J.

Originally posted by patooyee
I'm not worried about easy. I'm worried about $$$! :(

J. J.

Check out this other link that was active the other day, covers most of the issue - it has a link to the www.coloradok5.com forum.

Link is - www.pirate4x4.com/forum/showthread.php?s=&threadid=23043

I am in the process of doing the same conversion. Went to a junk yard got the intake throttlebody and ECu with prom out of a 91 for 200.00 dollars. Call centech wiring for the harness they run about 350.00. Do not use painless they are far from there name. Hope this helps.