|
FIXXXXAH 01-13-2002, 03:31 PM OK. I have taken all 5 mounting bolts out from the X-fer case, the retaining nut is off the end of the input shaft, and i cant get the fawking tranny apart from the xcase:mad3: it'ss pissing me off, i can spin the whole tranny around, and it till pull out around 1/16" but thats it. is there a snap ring behind the bearing on the input shaft that i dont know about here? i need a responce as soon as i can. Thanks, Matt :mad2: Lord Baskerville 01-13-2002, 03:43 PM Matt, I've ussually used a two jaw puller bolted to two of the rear cover spots then centered the puller on the shaft and pushed/pulled the t-case off the output shaft of the tranny. No puller:D Rest the t-case on something with the tranny hanging down and beat on the shaft with a BFH and a board. The shaft is just sticking on the bearings... Or, the splines are soo messed up between the trans shaft and the t-case gear that the splines are binding. In this case, hit it with anything you want cuz you need a new output shaft and gear.:flipoff2: Cory FIXXXXAH 01-13-2002, 04:13 PM Well, i went ballistic and grabbed a BFH and a peice of channel and went nuts and it came right out. guess thats the key to everything right?:D just bound up in the bearing. Thanks for the post Cory, or should i say Clark? :p Matt | |