|
clc900 01-14-2002, 09:35 AM From a mag I get this: Centerline of axle to the pinion height is: 9inch = 2 3/8 below centerline D60 = 1 1/8 below centerline RC60 = 1 1/8 ABOVE centerline Anyone have the figures for the following: 14 bolt = ? D44 = ? D70 = ? Thanks, Chad clc900 01-14-2002, 07:09 PM Come Awn Guys!! Help a po brotha out!!!!! I am mainly interested in how a 14 bolt compares in pinion height to a 9" and a D60. Higher, lower, in between???? What??? Chad GearMan 01-14-2002, 07:44 PM the 70 is the same as a 60 and the 14 bolt is closer to centerline then either of those i think if i remember right it is as close as you can get and still have a HYPOID cut gear once you are on centerline it becomes a straight bevel cut clc900 01-15-2002, 07:18 AM Thats good to hear. I was under the impression that the 14 bolt was between the 9 inch and tyhe D60. If its higher than the D60 that is a good thing.:) Can any of you 14 bolt users confirm this? Also, I saw some pics of Lakerats shaved 14 bolt. Like 2 inches came off. Anyone know how it is holding up for him? Thanks, Chad | |