PDA

: new high angle toy rear shaft

Booger Weldz
05-15-2004, 07:31 PM
new rear driveshaft from high angle, clearanced cv joint, 43-48''(ill get exact numbers for you), $200
Booger Weldz
05-16-2004, 07:02 PM
bump
CGuava
05-16-2004, 07:42 PM
could i get and exact measurement? my rear needs to be 43" in the middle of the slip.

christian
3Wheel_Drive
05-16-2004, 08:40 PM
how long is the slip on the d-shaft?
Booger Weldz
05-17-2004, 05:18 PM
how long is the slip on the d-shaft?
its 46'' when installed on my truck, its the ifs style spline, like 4-5''
Booger Weldz
05-18-2004, 05:29 PM
bump
CGuava
05-18-2004, 10:39 PM
too long for me man, thanks for checking though....ttt
Booger Weldz
05-20-2004, 03:44 PM
bump
Genshie
05-21-2004, 06:59 AM
Booger, PMed you.....

Kurt G.
Stump1883
05-21-2004, 08:08 AM
I'm not 100% sure on what length I need, I'll go measure when I get home, but to make sure, it's the automotive slip spline, no agricultural stuff right? I can't have vibes. on my D/D. Let me know if it's sold.
Booger Weldz
05-21-2004, 08:33 AM
I'm not 100% sure on what length I need, I'll go measure when I get home, but to make sure, it's the automotive slip spline, no agricultural stuff right? I can't have vibes. on my D/D. Let me know if it's sold.
no vibes, this is made for the rear, daily driver/rockcrawler, highway speeds...the spline section and joints are factory parts, the cv joint is shaved by jesse around the yokes for more clearnace/angle...
Booger Weldz
05-22-2004, 08:23 PM
bump, $200 for a new shaft :D
Booger Weldz
05-23-2004, 06:54 PM
bump